The prospect of completing Vehicle maintenance, even a seemingly basic chore like an oil change, can be intimidating, if not impossible. On the other hand, changing your oil can be more convenient and cost-effective than taking your car to a local express lube business.
Consult your owner’s handbook before you start this process to see exactly how much Car engine oil you need to replenish for what you drain. And an oil filter will be needed, too. So you’re going to make a visit to a car shop or a large shop to obtain what you need. You are there, and if you don’t have an oil filter bracket, you will want to pick the right size clamp for your oil drain plug. And you want to keep your hands clean with a few gloves.
Prepare the car
When you start your engine, it should be warm, but not hot. Allow the car to sit for a few minutes to allow the exhaust system to cool down, but don’t let it get completely cold.
If you need to raise the vehicle for easier access, now is the time to do so.
Remove the undercover if necessary. Aerodynamic covers are used on some newer cars to improve fuel economy and keep things clean. Unfortunately, the covers have the potential to conceal the engine’s oil drain plug and oil filter. Some covers include built-in access hatches that are usually labeled. Sometimes you have to remove the undercover completely. The good news for us do-it-yourselfers is that most automobiles do not have them. The Explorer does, but it’s held in place by four twist-release clips that can be removed without using any tools.
Unplug It, Drain It
Set up your oil receptacle—a five-gallon bucket, an oil drain pan (available at auto parts stores), an oil reservoir, or any other large liquid-holding container—so that the oil drains into it without spilling or making a mess.
Remember that there will be a lot of oil: most cars have at least a gallon of fuel in the crankcase, and some have much more. Unscrew the drain plug with the appropriate wrench after loosening it (counterclockwise). Pull the drain plug away from the oil pan while holding on to it; the oil will begin to flow out as you do so. Allow the engine to drain for 5 minutes or until the oil flow has been reduced to a trickle.
Check the oil drain plug and clean the auto oil as the remaining oil drains. This is where if one were necessary, the new drain plug washer would go. Tighten the drain plug.
Change the oil filter, add new oil
Remove the oil filter from the engine. New filters that have been correctly placed do not have a particularly tight fit. However, because their sealing gaskets enlarge over time, they can be difficult to remove subsequently.
It’s time to add Automotive engine oil once you’ve double-checked that the oil drain bolt and filter are both in position and properly tightened. Add about one quart less than the amount required.
Bottom line
If you are going to change the oil, just know about the engine oil and Canadian tire oil. Besides, if you are unable to do it yourself, you can always ask for assistance from the expert team of Scrap Car Removals.